Skip to content 
Container Opening Reinforcement Calculator
Cutting steel weakens the structural integrity of your container. Use this estimator to determine the required framing (HSS Tubing) to prevent roof sag and wall failure.
1 Container Specs
STOP: DIY Calculators cannot certify stacked containers.
2 Opening Dimensions
Engineering Assessment
Structural Risk
Recommended Header Size
HSS 2×2 x 1/8″
Square TubeStandard framing for attachment. Minimal load transfer.
Estimated Reinforcement Plan:
- Header: HSS 2×2 welded to adjacent corrugations.
- Jambs (Columns): HSS 2×2 full height from floor to header.
- Sill: HSS 2×2 (Required for window rigidity).
Need this approved for a permit?
This tool is for estimation only. Building departments require signed & sealed drawings.
Engineering Consultation Required
You have selected a configuration (2-story or massive span) that exceeds standard DIY prescriptions. This requires specific load calculations.
Legal Disclaimer & Limitation of Liability
This calculator is a conceptual planning tool provided by Oasis Engineering for preliminary estimation purposes only. IT IS NOT FOR CONSTRUCTION. The outputs generated herein do not constitute a professional engineering service, design, or certification. Structural integrity of shipping containers varies by manufacturer, age, and condition (rust/dents). Cutting any portion of a container’s corrugations or rails compromises its diaphragm action and load-bearing capacity. Oasis Engineering assumes NO LIABILITY for failures, injuries, or financial losses resulting from the use of this tool. You are solely responsible for ensuring compliance with all local building codes (IBC/IRC), wind loads, snow loads, and seismic requirements. A site-specific structural analysis signed and sealed by a licensed Professional Engineer (PE) is required for permitting and safe construction.
